Table of Contents
Advertisement
10.
Select No and press Enter.
11.
In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice.
12.
Select your optical drive from the options on the screen, then, press Enter.
13.
Read the message on the screen, and select the way to recover your system; then,
press Enter. If you select Formats hard disk and creates new partition, go to the
next step. Otherwise, go to Step 15.
When you select Recovers both C: and D: drive or Formats hard disk and
creates new partition, the recovery process will delete the recovery data
installed in the hard disk. Therefore you will not be able to recover your
system from the hard disk.
14.
Select the volume of C: drive and press Enter.
15.
Read the message and select Continue; then, press Enter. Follow the on-screen
instructions for replacing the recovery CDs.
Although the pointer may be shown on the screen, never touch the
keyboard, the mouse or the screen during recovery except when the
message prompts you to. If you touch them, the re-installation will be
canceled.
16.
After the recovery process completed, the system will start automatically. When
the message Press F2 for System Utilities appears, press F2. The Setup Utility
will open.
17.
In the Exit menu, select Load Setup Defaults; then, press Enter twice.
18.
In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter
twice. The system will restart.
19.
Set up Windows, following the instructions on the screen. Make sure to set date
and time.
20.
Remove the external optical drive if you don't use it.
When you disconnect the external optical drive, you need to stop the
device. Follow the instructions on USB Device section of Chapter 5.
A-16
Advertisement
Table of Contents
