Table of Contents
Advertisement
10.
Remove the external optical drive if you don't use it.
When you disconnect the external optical drive, you need to stop the
device. Follow the instructions on USB Device section of Chapter 5.
Recovering with Recovery CD
• When you format entire of the hard disk drive (both C: and D: drives),
the recovery data installed in it will be eliminated. Therefore you will
not be able to recovery your system via hard disk.
• Be sure to use one of the recommended drive units (LITEON LSC-
24081MX USB Drive (Combo) or SHARP CE-CD05).
1.
Make sure your computer is turned off.
2.
If any peripheral devices are connected to your computer, disconnect them.
3.
Connect an external optical drive unit.
4.
Connect the AC adapters to your computer and the external CD drive unit; then,
turn on your computer.
Be sure to connect the AC adapter. If the battery is completely
discharged, the installation process will be canceled.
5.
When the message Press F2 for System Utilities appears, press F2. The Setup
Utility opens.
6.
Insert the Recovery CD disc 1 into the optical drive.
Always hold the CDs by the edges. Fingerprints, dirt or water on the
CDs cause improper tracking. If a CD is dirty or does not work properly,
clean it with a soft, dry cloth, wiping straight out from the center, along
the radius.
7.
In the Exit menu, select Load Setup Defaults; then, press Enter twice.
8.
In Boot Sequence of the Boot menu, set CD-ROM Drive to the top of the list;
then, press ESC.
9.
In Advanced menu, select Plug & Play O/S and press Enter. The sub menu will
open.
A-15
Advertisement
Table of Contents
