Pre-Filter Cleaning - Kenmore 116.10065 Use & Care Manual

PRE-FILTER CLEANING
To Reinstalh
The pre-filter is located inside the dust
cup. Check the pre-filter frequently and
clean when dirty.
1. Remove the dust cup as outlined in the
EMPTYING DUST CUP (page 16).
NOTE: Make sure dust cup is free of
debris before opening the dust cup lid
assembly.
2. Rotate dust cup lid assembly
counterclockwise as indicated on the dust
cup and lift off.
Lid Assembly
LOCKED
(For Use)
3. Grasp pre-fitter
and rotate
counterclockwise
to remove.
UNLOCKED
(For Cleaning)
4. Clean pre-fitter
by gently tapping
over a trash
container. Tap on
several sides to
ensure best
cleaning.
If necessary, rinse with cold water only,
DO NOT use detergent or soap. Allow
parts to dry 24 hours before putting back
into vacuum cleaner.
DO NOT wash in the dishwasher.
DO NOT install damp.
1. Align the slots
on the pre-filter
with the //,
alignment tabs
inside dust cup ,//;
lid assembly.
2. Rotate pre-
filter clockwise
to lock in
place.
-Tabs
.Slots
3. Replace the lower portion of the dust
cup by aligning marks as shown,
UNLOCKED (For Cleaning).
UNLOCKED
(For Cleaning)
LOCKED
(For Use)
4. Rotate while pressing downward until
marks align as shown; LOCKED (For Use).
5. Reinstall the dust cup. See EMPTYING
DUST CUP (page 16).
=17=