Programming Recordings With Vcr Plus+ System - Philips DVDR615 User Manual

Timer Recording
Programming recordings
with VCR Plus+
®
With the VCR Plus
only need to enter the PlusCode
programming number as all the
information needed by the DVD recorder
for programming is contained in the
programming number.
1
Turn on the TV power. Select the correct
Video In channel at the TV.
2
Press TIMER on the remote control.
➜
The timer overview appears.
3
Press the matching color coded button
on the remote control to select
{ VCR Plus+ .}
➜
®
The VCR Plus+
4
Use the alphanumeric keypad 0-9 to
enter the PlusCode programming number
for the show you wish to record.
(e.g. : 5-312-4 or 5,312 4, key in '53124'.)
➜
This number is up to 8 digits long and
can be found next to the start time of the
TV program in your TV listings magazine.
TIPS: To play a DVD+R on other DVD players, see "Finalizing disc (DVD+R)."
During timer recording, press STANDBY-ON will stop recording.
46
DVDR610_615_37_Engfinal434
(cont'd)
®
System
program system, you
entry screen appears.
46
G
To clear the PlusCode programming
number, press the matching color coded
button on the remote control to select
{ Clear .}
G
To cancel the VCR Plus+
press the matching color coded button
on the remote control to select
{ Cancel .}
➜
The timer overview appears.
5
Press OK to confirm, then press the
matching color coded button on the
remote control to select { Store .}
➜
The system will store the timer entry
and return to the timer overview screen.
G
If the channel number of the TV channel
has not been assigned to the PlusCode
number, you will be asked to enter the
preset number/channel. Follow the
instructions on the TV.
G
If the information is missing or not
available, you may be asked to enter more
information. Follow the instructions on
the TV.
G
If you want to make changes, use
3 4 1 2 to select the appropriate entry
field. If required, make changes using 3 4
or the alphanumeric keypad 0-9.
6
To exit, press TIMER.
7
Insert a DVD+R(W).
8
Press STANDBY-ON to switch off the
DVD recorder.
➜
The DVD recorder must be in standby
mode in order for the timer recording to
occur. If not, a warning message will
appear ten minutes before the recording
starts.
➜
If you ignore the warning message, the
DVD recorder will switch to standby
mode automatically before the
programmed recording begin.
➜
The ' ' icon will light up on the
TIMER
display panel if a timer recording is set.
8/18/04, 2:56 PM
® programming,
3139 246 14221