Note: Make sure you have successfully
made all the required connections to the
DVD recorder, the TV and Satellite
Receiver/Cable Box (if any) and switched
them on. The automatic channel search
will detect the signals and save all the
available program channels.
0
Press OK again to start automatic TV
channel search.
!
When TV channel search is complete,
press OK to continue.
➜
The { Time and Date } menu appears
on the TV.
"
Check if the information on the menu is
correct.
➜
If required changes, follow steps
of "Setting the time and date" on page 28.
§
Press 4 to select { Done } and press OK
to save the changes.
$
Introduction dialog about YesDVD
appears on TV. Press OK to continue.
➜
The first installation is now complete.
➜
The first tuned TV channel appears.
The DVD recorder is ready for use!
TIPS:
Press OK to exit the initial installation menu.
Press RETURN to go back to previous menu item.
DVDR610_615_37_Engfinal434
Installing the DVD Recorder
Helpful Hints:
– If the DVD recorder cannot find any TV
stations, select program number {1} on the
TV set or check the cable connection from
the antenna jack to the DVD recorder and
TV set.
– If the sound or picture is distorted on any
of the stored TV channels, see pages 26~27
"TV channel programming" for manual TV
search.
4~8
25
(cont'd)
3139 246 14221
8/16/04, 4:05 PM
25