Table of Contents
Advertisement
7.6
Data Storage
7.6.1 Submenu <Data Storage><<Hard Drive>>
F
IELD
Disk Full Behavior
Disk 1 Status
Disk 2 Status
Total Capacity
7.6.2 Submenu <Data Storage><<Archive>>
See Archiving, Section 10.
7.7
System
7.7.1 Submenu <System><<Password>>
F
IELD
Password Protection
Available Actions:
• Set Password. Press front panel buttons 1 through 4 to set the password (four to ten characters).
NOTE: This password is the same password used by the Hi-Q Management Utility.
7.7.2 Submenu <System><<Network>>
The Network menu allows access to settings that control the behavior of the recorder with respect to a network.
• Enter the IP, Subnet Mask, and Default Router addresses.
• Enter a Hi-Q recorder name to be used on the network.
F
IELD
IP Address
Subnet Mask
Default Router
Name
* See Appendix D for Hi-Q on-screen character set.
** XXXX is the last 4 digits of the Hi-Q recorder serial number.
V
ALUES
• Overwrite
• Stop Recording
• Good
• Bad
• Good
• Bad
• Not Installed
Hard disk capacity, in GB
V
& D
ALUES
EFINITION
• Enabled (requires password
for menu access)
• Disabled (no password
required for menu access)
V
ALUES
[0–255 in each block]
[0–255 in each block]
[0–255 in each block]
[12 Characters]*
21
D
V
EFAULT
ALUE
Overwrite
• Stop Recording is the
default (non-adjustable) if
a disk array is recognized
Calculated
Calculated
Calculated
D
V
EFAULT
ALUE
Disabled
D
V
EFAULT
ALUE
10.10.0.0
255.255.255.0
10.10.0.1
Hi-Qxxxx**
Advertisement
Table of Contents
