Ice Maker Cleaning - Hitachi R-X730FJ How To Use Manual

MAINTENANCE
Warning

Ice Maker Cleaning

Wash the Ice Tray or water paths with water.
Be sure to check the followings before
starting the operation.
Go to the next step after checking them.
1
Close all the doors.
2
Touch
All indicator lamps turn on, and then the current settings are displayed.
3
Hold down
sounds.
When the 3 indicator lamps " 急速製冰 (Quick Ice Making) " , " 製冰 (Ice Making) " and " 製冰停止 (Stop) "
start to blink and alarm starts to sound, stop holding the button.
" 製冰機清潔 (Ice Maker Cleaning) " starts (for about 4 minutes).
・ The indicator lamp will flash and the buzzer will sound for about 4 minutes.
・ " 製冰機清潔 (Ice Maker Cleaning) " can ' t be interrupted.
・ If you open any of the refrigerator doors during Ice Maker Cleaning, the cleaning may not work properly. Do
not open or close the door until cleaning is completed.
・Door alarm sounds even if alarm is disabled.
4
Place a clean towel, etc. on the bottom in
the Ice Case so that the cutout of the Ice
Case can be blocked after the alarm and
blinking of the indicator lamp end.
Place a water-absorbing towel on the bottom in the Ice Case to
prevent trapped water during the ice maker cleaning from spilling out
of the cutout of the Ice Case.
5
Wipe off water inside the Ice Case completely, and then set
it to the Ice Compartment.
Remove the towel with which you have wiped off water.
There is no problem with using water remaining in the water supply container, if any.
After " 製冰機清潔 (Ice Maker Cleaning) " , it is set to " 製冰 (Ice Making) " mode, etc.
68
(CONTINUED)
● Do not place your hand in the mechanical section
of the automatic ice maker.
(Rotation of the ice tray may cause injury.)
When using for the first time
button on the Control Panel to turn on the indicator lamp.
button for 5 seconds or more until the alarm
Pg.63
When not used for more than one week
Water supply container
・Water is filled in it up to the limit line.
・ It is set correctly beyond the tank
set position line.
Ice case
・If there remains ice, remove it.
R-X730FJ
Cutout
Towel
1 1 - 4
It blinks
Touch it
R-X670FJ, R-G670FJ
Cutout
Towel