Set The Condensation Prevention Heater To Min - Hitachi R-X730FJ How To Use Manual

VARIOUS FUNCTIONS

Set the condensation prevention heater to MIN.

Setting the condensation prevention heater to MIN saves energy.
When dew is formed in the swing partition or the partitioning iron plates, set it to the standard.
The temperature settings for the swing partition and the partitioning iron plates can be adjusted by four levels (1 to 4), and
level 4 is the most energy saving.
MIN setting of the
heater
Preset sound
Setting the swing partition
1
Open the door of the Lower Freezer Compartment.
2
Touch
All indicator lamps turn on, and then the current settings are displayed.
3
Press down
The setting of MIN level of the dew condensation prevention heater will be switched.
Repeat the above-stated operation to set it to the level you prefer (see the table above).
4
Close the door of the Lower Freezer Compartment.
Setting the partition iron plate
1
Open the door of the Lower Freezer Compartment.
2
Touch
All indicator lamps turn on, and then the current settings are displayed.
3
Press down
The setting of MIN level of the dew condensation prevention heater will be switched.
Repeat the above-stated operation to set it to the level you prefer (see the table above).
4
Close the door of the Lower Freezer Compartment.
Notice
● The setting will be returned to the standard when the power plug is disconnected and connected or power failure recovery takes place.
64
MIN setting
Standard
level 1
−
Long beep
(Factory setting)
button on the Control Panel to turn on the indicator lamp.
button for 3 seconds or more until the preset sound is heard.
button on the Control Panel to turn on the indicator lamp.
button for 3 seconds or more until the preset sound is heard.
(CONTINUED)
(Swing partition/Partitioning iron plates)
MIN setting MIN setting
level 2 level 3
Long beep (2 beeps) Long beep (3 beeps) Long beep (4 beeps)
Swing partition
Partitioning iron plates
MIN setting
Standard
level 4
2 beeps