Configure Trap Destinations - GE IC755CxS06RDx User Manual

Software
For public disclosure
The following sections provide the procedures to enable and configure the QuickPanel
device to operate as a SNMP Agent and establish communication with a SNMP Manager.
•

Configure Trap Destinations

• Enable or Disable SNMP Agent
Export MIB to SD Card
•
• Load MIB into SNMP Manager
• Data Types Mapping between PME Project and SNMP
• Establish SNMP Communication
3.14.1 Configure Trap Destinations
TRAP Destinations are configured through the QuickPanel
IP Address of the SNMP Manager to which Traps should be sent. The user can configure
two different Trap Destinations (IP Addresses).
Note If you do not want to be notified of Traps, you do not need to configure Trap
Destinations.
➢ ➢ To configure Trap Destinations
Attention
1. From the Start menu, select System, open the QuickPanel
select the SNMP Agent tab.
2. Configure the Trap destination(s) of the SNMP Manager.
Click OK to save the changes.
3.
Close the QuickPanel + Setup Tool, then re-open the tool to view the configured Trap
Destination details from the SNMP Agent tab.
If Trap Destination(s) is/are configured after
enabling the SNMP Agent on the device, it is highly
recommended that you disable and then re-enable
the SNMP Agent service on the device.
Enter the IP Address(es) of the SNMP Manager to which
Traps should be sent.
+
+
Setup Tool by providing the
+
Setup Tool, and
GFK-2847R 49