Fitting The Optional Roof Flue Kit (Flat Or Pitched) - IDEAL LOGIC CODE COMBI ESP1 26 Installation And Servicing

2.11 FITTING THE OPTIONAL ROOF FLUE KIT (Flat or Pitched)

Note.
A flat or pitched roof flashing plate (not supplied) is required before proceeding
with the installation of this kit.
This kit is suitable for both flat and pitched roof terminations, using a concentric
flue to run vertically from the top of the boiler and terminating above roof level.
Connection to the top of the boiler is made using the vertical connector.
WEATHER PROOFING
Where the flue passes through the roof line an adequate seal must be made.
This is achieved by using either:
- Flat roof weather collar
or
- Universal weather collar.
ACCESSORIES
Flue Duct Extension Kits are available for flue lengths extending beyond 1m.
These packs contain 500mm, 1000mm and 2000mm extension ducts and may
be cut to the desired length.
If the offset vertical option is used an Elbow Kit is required.
Please visit www.idealboilers.com to access the Flue and Accessories Guide
for this boiler.
Installation and Servicing
SECTION 2 - INSTALLATION
nm8736
25