Accessing The Setup Utility; Navigating Through The Setup Utility - HP ProLiant DL170e G6 Software Configuration Manual

NOTE: If you repeatedly receive "Run Setup" messages, the battery located on the system board
(XBAT1) may be defective. In this case, the system cannot retain configuration values in CMOS. Ask
a qualified technician for assistance.
The Setup Utility loads the configuration values in a battery-backed nonvolatile memory called CMOS
RAM. This memory area is not part of the system RAM, which allows configuration data to be
retained when power is turned off. The values take effect when the system is booted. POST uses these
values to configure the hardware. If the values and the actual hardware do not agree, POST
generates an error message. You must run the Setup Utility to change the BIOS settings from the
default or current configuration.

Accessing the Setup Utility

Turn on the monitor and the server.
1.
If the server is already turned on, save your data and exit all open applications, then restart the
server.
During POST, press F10. If you fail to press F10 before POST is completed, you need to restart
2.
the server and repeat this step. The first page displayed is the Main menu. Use the left (←) and
right (→) arrow keys to move between selections on the menu bar.
Figure 1 Main menu
NOTE: System Serial Number and Asset Tag are not updated even when CMOS defaults are
loaded or CMOS is cleared.

Navigating through the Setup Utility

Use the keys listed in the legend bar on the bottom of the Setup screen to access the various menu
and submenu screens of the Setup Utility. Figure 1in the previous section shows the legend bar at the
bottom of the Main menu. Table 1 lists these legend keys and their respective functions.
System BIOS configuration 5