Philips DVDR 80 Owner's Manual page 36

7
Select the desired screen format with
setting only functions if you have inserted a DVD recorded in this
format.
for wide-screen TV (16:9) aspect ratio
8
Confirm with
9
After you connect the antenna (or cable TV, satellite receiver,
etc.) to the DVD Recorder, press
Make sure the cable TV signal is connected securely to the
Antenna jack on the rear of the DVD Recorder.
The automatic TV channel search starts. '
display.
a
b Select another channel on the TV. Do you see that channel on the TV
screen?
If not, check the cable connection of the antenna (antenna jack)
between the DVD Recorder and TV.
b Please have patience.
The DVD Recorder searches the entire frequency range in order to
find and save the largest possible number of TV channels.
b If no antenna is connected, complete the basic settings and then, if
desired, start the automatic channel search (see section 'Automatic TV
channel search').
a
b It is possible that the automatic switching between antenna/cable does
not properly detect your TV signal. Read the section about how to
switch manually.
10
Wait until all available TV channels have been found. This can
take several minutes.
11
As soon as the automatic TV channel search is completed, '
the number of channels found.
12
To remove the menus, press the
the Recorder's remote control.
Further settings relate to the GUIDE Plus+
TV programs available in your area.
To install this system, please read section 'The GUIDE Plus+
B or A
for a wide-screen display (theatrical format) with black
bars at the top and bottom of the picture.
for a full-height picture with the sides trimmed to fill you
TV screen.
.
.
' will appear on the TV screen along with
® system. This offers a free interactive guide to the
. This
' will appear on the
button on
® system'.
Installing your DVD Recorder