Philips DVDR 80 Owner's Manual page 110

Philips digital video disc recorder owner's manual dvdr 80
Hide thumbs Also See for DVDR 80:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
SOLUTION
b
It is possible that this (Super) Video CD contains a menu and the 'PBC' is switched off. You
can see this in status field '
Press
1
' using D or C .
Select '
2
Select line '
(
3
Select '
' in line '
4
Confirm with
5
b
Your TV is not properly adjusted.
b
The disc is dirty: Clean the disc.
b
Sometimes the picture may be temporarily distorted. This is not a defect of your DVD
Recorder.
b
The TV channel you want to record is not stored or you selected the wrong program
number: Check TV channels stored.
b
Disc is write-protected (cannot be recorded on): Remove write-protection or change the disc.
For more information, please see 'Preventing accidental erasing of discs' on the 'Manual
Recording'.
b
A finalized DVD+R has been inserted. Change disc.
b
You have set the wrong time or date: Check time/date.
b
You have not set the TIMER properly: Check the programmed recordings (TIMER block).
b
A locked disc was inserted: Remove disc lock.
b
A finalized DVD+R has been inserted. Change disc.
b
Cabelbox (if available) switched off: Switch it on
b
IR-Blaster not connected: Connect the IR-Blaster andset up the GUIDE Plus+
the cable box. (Chapter 'The GUIDE Plus+
system').
b
Wrong cable connection selected
b
Wrong channel line up selected.
b
The Demo Pin from the
removed.
Disconnect the DVD Recorder from the power outlet.
1
Remove the DEMO pin from the
2
Recorder
Re-connect the Recorder to the power supply.
3
b
The Infrared (IR) Remote control signal interfere with the IR signal of the IR Blaster
Put the IR Blaster closer to the front of the cable box.
b
The number of TV channels depends on the setting in the GUIDE Plus+
If you have a Cable Box installed (Cable Box 'YES'), then you should switch on the available
channels (Channels above 125).
b
If you have no Cable Box installed (Cable Box 'NO'), then you should switch off the channels
which are not available.
'. To activate this function, proceed as follows:
while the (Super) Video-CD is inserted.
B or A
)' using
B or A
' using
and end with
®
system, section 'Setting up the GUIDE Plus+
jack on the backside of the DVD Recorder was not
jack on the backside of the DVD
Before you call technical support
and confirm with C .
.
.
®
system with
®
sytem settings.
®

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dvdr800Dvdr 80/17

Table of Contents