Initial Inspection; General - Jacobsen AR-522 jossa ROPS Safety & Operation Manual

3

INITIAL INSPECTION

3.1

GENERAL ________________________________________________________________

The inspection and testing of the unit should always be
performed by a trained technician, familiar with the
operation of this equipment.
Read each instruction completely and make sure you
understand it before proceeding. Stay alert for potential
hazards and obey all safety precautions.
The RIGHT and LEFT, FRONT and REAR of the
machine are referenced from the operator's seat, facing
forward.
Accessories not included with this product must be
ordered separately. See instructions provided with
3.2 INITIAL INSPECTION _______________________________________________________
The initial inspection should be performed only when the engine is off and all fluids are cold. Lower mowers to the
ground, engage the parking brake, stop engine and remove ignition key.
1. Perform a visual inspection of the entire unit. Look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important operating and safety
information. Notify dealer, and replace all missing or
hard to read decals.
3. All fluids must be at the full level mark with engine
cold.
Check:
a. Radiator coolant level
b. Engine oil level
c. Hydraulic fluid level
4. Make sure air filter connections are tight and cover
is securely in place.
accessory for installation and parts.
Do not attempt to drive the mower unless you are
familiar with this type of equipment and know how to
!
CAUTION
5. Check tires for proper inflation. Tires have been over
inflated for transport. Correct tire pressure should be
set to:
Front ......................... 16 psi (111 kPa)
Rear .......................... 12 psi (86 kPa
6. Check belt tension.
[Parts & Maintenance Manual, Section 3.3]
7. Inspect battery connections and electrolyte level.
Check that battery is fully charged.
8. Check for fuel or oil leaks.
9. Inspect lube points on decks and mower for proper
lubrication.
[Parts & Maintenance Manual, Section 6.3]
INITIAL INSPECTION
!
CAUTION
operate all controls correctly.
3
9