Setting The Water Softener - Electrolux ESI 64010 User Manual

6 electrolux

Setting the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation of
the appliance.
Water hardness is measured in equivalent
scales:
• German degrees (dH°).
Water hardness
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The water softener is set at the factory
at level 5.
1. Switch on the appliance.
www.markabolt.hu
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
• Clarke.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
mmol/l Clarke
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
2. Make sure that the appliance is in setting
3. Press and hold function buttons B and C
4. Release function buttons B and C.
5. Press function button A.
6. Press the function button A one time to
7. Press the on/off button to save the oper-
for the hardness of water).
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
mode.
until the indicator lights for function but-
tons A, B and C start to flash.
– The indicator light for function button A
continues to flash.
– The indicator lights for function buttons
B and C go off.
– The end-of-programme indicator light
starts to flash.
The setting function of the water softener
is activated.
The end-of-programme indicator light
flashes to show the level of the water
softener. The pause is approximately 5
seconds.
Example: 5 flashes, pause, 5 flashes,
pause, etc. = level 5
increase the water softener level by one
step.
ation.
electronically
10
9
8
7
6
5
4
3
2
1)
1