Messages.and.alarms; Messages - Pentair Goyen Precision P1 Installation And Operating Instructions Manual

MESSAGES AND ALARMS

MESSAGES

Scrolling.Display
DISPLAY
Model xx.xx
Continuous Mode P2
Demand Mode P2
On Time = xxx ms
Off Time = xxx sec
Slaves = xxxx
Blowdown cycles = xxxx
Remote Stop = Hardwired P2
Remote Stop = Automatic P2
Hour Counter = xxHrs
Total Cycles = xxxxxx
Max. Interval = xxx P2
Pattern Cleaning = xxx P2
Alarm Delay = xxx sec P2
Tube Cleaner = xxxx
Units = xxx P2
P2 Only for the P2 interface.
General.Messages
DISPLAY
dP = xxxx (units)
P2
Stopped (dP) P2
Stopped (Fan)
Manual Cycle P2
Cycling – Paused P2
Cycling –(Precoating) P2
xxx sec
xx:xx
Tube Cleaner xx sec
P2 Only for the P2 interface.
18 INSTALLATION AND OPERATING INSTRUCTIONS PRECISION
DESCRIPTION
Software version number
Controller is in Continuous Mode
Controller is in Demand Mode
Electrical On Time of Solenoid
Electrical Off Time of Solenoid
Number of Slaves connected to Controller
Number of complete cleaning cycles the controller performs after the fan has been switched off
Remote Stop is hardwired to the fan or circuit breaker
Remote Stop is dependent on dP of system
Number of hours the controller has been operational
Number of complete cleaning cycles the controller has performed
The maximum time that can elapse before a cleaning operation takes place (only in use when in
Demand Mode)
Allows the controller to 'Off', 'Skip 1' or 'Skip 2' outputs (refer to cleaning patterns)
Delays high dP and Auxiliary Alarm for this amount of time to avoid false alarms due to system spikes,
etc.
'Off', 'Tube Cleaner Duration' and 'Tube Cleaner Period'
Current units being used for display of dP
DESCRIPTION
Current dP
Remote Stop due to Automatic Blowdown dP measurement
Remote Stop due to Hardwired Blowdown
Either the Manual Cycle button or contact (P-CTX) has been activated. The controller is now performing
one complete cleaning cycle with the programmed On and Off Time.
Controller waiting for dP to exceed High dP Limit value
Controller waiting for dP to exceed Precoating value
Countdown to next solenoid operation
Next SLAVE# : OUTPUT# to operate
Controller is performing a Tube Clean operation with xx sec remaining
FILTER CLEANING SYSTEM CONTROLS
®