Other Programming; Registering A Unit - Panasonic KX-TGM420AZ Operating Instructions Manual

Other programming

Changing the handset
name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 47).
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Displaying the handset
name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN#105
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Changing the unit's region
setting/Resetting the base
unit
1
MMENUN#136
2
MbN: Select the desired country. a
MSELECTN
"Australia" = Australia
"New ZealandsNewZealand" = New
Zealand
3
MbN: "Yes" a MSELECTN a MOFFN
Note:
R Changing the unit's region setting may
cause the settings for your country or your
customised settings to return to their default
settings.
0605_TGM42xAZ OI_ver002.pdf 47

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 6 for information on the available
model.
Registering a handset to
the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATOR/INTERCOMN
for about 5 seconds.
R If all registered handsets start ringing,
press MLOCATOR/INTERCOMN again
to stop, then repeat this step.
3
Handset:
Press MOKN, then wait until a long beep
sounds.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN#131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a MSELECTN
3
MbN: "Yes" a MSELECTN a MOFFN
Programming
47
5/6/2016 5:01:41 PM