IHI 15VX Operation Manual page 92

Change the Fuel Filter Element
* Hot oil and components can cause personal
injury.
* Fuel leaked or spdled on to hot surfaces can
cause a fire.
1. Stop the engin
2. Turn the fuel stop lever
position. Loosen the ring nut
3. Remove the cup
4. Drain water and sediment into a suitable
container.
NOTE: Always dispose of drained fluids as
established by local regulations.
5. CIean the inside surface of the cup.
6. Install the new element
7. Install cup . TIghten ring nut
8. Turn the fuel stop lever
position.
NOTE: Do not start the engine until aIl fuel system
service is completed.
9. There should be enough fuel in the system to
allow the engine to start. Keep the engine start
switch key at ON for a period of 20 seconds. which
operates the fuel pump and priming automatically.
Check the TraveT Drives Oil Level
When the quantity of oil is found to have
increased abnormauy, tt is necessary to check
the oil seal of the travel motor.
If the seal is leaking, contact a IHI dealer.
1. Position one travel dhve with oil drain plug
the bottom.
2. Remove the oil level/fill plug
the bottom of the level plug opening.
3. Add oil through the opening of oil level/fill plug
if necessary.
4. Clean the plugs
5. Perform procedure on the other travel drive.
MAINTENANCE
WARNING
to the "closed"(OFF)
.
and the element
.
.
to the "opened" (ON)
CAUTION
Oil should be to
. lnstall the plugs .
.
Close
Lever
at
3 – 23
500HOURS
Fuel filter
Ring nut
Open
Cup
Element
Fuel filter
Oil level / fill plug
Drain plug