IHI 15VX Operation Manual page 78

REPLACE THE TEETH AND SIDE CUTTERS
* Personal injury or death can result from
bucket falling
* Block the bucket before changing bucket
tooth or side cutter.
Replacement Period of Tooth
Replace the bucket tooth when a wear hole
appears.
Replacement of Tooth
1. Drive the lock pin from the worn tooth.
Remove the tooth.
2. CIean the adaptor and pin hole.
3. Install the new rubber pin into the tooth.
4. Install the new tooth over the adaptor.
5. Drive the lock pin through the tooth, until the
pin is flush with the tooth surface.
NOTICE:
After driving the lock pin, make sure the
lock pin fits snugly into the hole of the tooth.
Replacement of Side Cutters
1. Remove the mounting bolts and remove
the side cutters.
2. Clean the mounting surfaces. Install the
new side cutters.
MAINTENANCE
WARNING
Change
Adoptor
Rubber pin lock
Tooth
Wrong
Wrong
Wrong
3 – 9
WHEN REQUIRED
Over use
Tooth pin
Nose section
Rubber
Tooth pin
Wrong
Nut
Washer
Side cutter (R.H.)
Bolt
Side cutter (L.H.)
Block