Sony xperia z3 compact SO-02G Instruction Manual page 206

Table of Contents

Advertisement

When requesting a repair, make sure to
bring the warranty card with the terminal.
Repair requests that are not accompanied
by the warranty or that involve
malfunction and damage due to incorrect
handling by the owner (damage of
microUSB connection jack, headset jack,
liquid crystal, etc.) will only be repaired at
the owner's expense, even if the warranty
period is still effective.
Malfunction due to use of devices and
consumable parts other than those
specified by DOCOMO will only be
repaired at the owner's expense, even if
the warranty period is still effective.
Note that repair may be refused in the
following cases:
When the terminal has corrosion due to
wet by liquid, condensation, perspiration,
etc. or the internal circuit board is
damaged or deformed (we may not be
able to repair when the microUSB jack,
headset jack, liquid crystal, etc. is
damaged or the frame itself is cracked)
based on the result of our examination.
* Even if repair is possible, it will be done at the
owner's expense, as this type of corrosion or
damage is not covered by the warranty.
If the warranty period expires
We will repair the terminal at the owner's
expense.
Parts stock period
The functional parts necessary to repair the
terminal will be basically available for a
minimum of 4 years after the manufacture is
discontinued.
However, depending on the defective
portion, repair may not be possible because
of a shortage of repair parts. Note that repair
may still be possible depending on the
defective portion even if the stock period
has expired. Contact "Repairs" on the last
page (in Japanese only).
Precautions
Never modify the terminal or accessories.
Doing so may result in fire, injuries or
malfunctions.
The modified terminal may be repaired
only if the owner agrees on that all the
modified parts are restored to the original
conditions.
However, repairs may be refused
depending on the modifications.
The following cases may be considered as
modifications.
- Put a seal etc. on the liquid crystal or key
part
- Glued decorations on the terminal using
adhesion bond, etc.
- Change the parts such as exterior to
other than DOCOMO standard parts
204
Appendix/Index

Advertisement

Table of Contents
loading

Table of Contents