Buttonhole Sensor - ELNA 6001 Service Manual

PDFMAILER.DE
TO REMOVE
1. Remove the face and front cover (see page 8 and 11).
2. Remove screw (A), then remove the buttonhole sensor (B) from the sensor set plate (C).
3. Pull out the connector of buttonhole sensor unit (D) from the A-board.
4. Pull out the cord of buttonhole sensor unit from the cord guide (E), Then remove the buttonhole
sensor unit.
TO ATTACH
1. Attach the buttonhole sensor (B) on to the sensor set plate (C) with screw (A) lightly.
1. Slide the buttonhole sensor (B) back and forth slightly and make sure it doesn't touch the
buttonhole shield plate (F). (See illustration).
2. Tighten the screw (A) firmly.
2. Pass the cord as illustrated, and attach the front cover.
3. After replacing the buttonhole sensor, sew a few buttonholes.
4. If something is abnormal, adjust the "Buttonhole lever" (See page 22).

BUTTONHOLE SENSOR

30