Buttonhole - ELNA 6001 Service Manual

PDFMAILER.DE
TO ADJUST THE BUTTONHOLE LEVER GUIDE
1. Set the machine in buttonhole sensor adjusting mode. (See below, The LED should display "H"
or "L".)
2. Remove the face cover.
3. Lower the buttonhole lever. Loosen the setscrew (A) and position the buttonhole lever guide so
the LED displays "L".
4. Tighten setscrew (A).
TO ADJUST THE BUTTONHOLE SENSOR POSITION:
1. Install the buttonhole foot (R).
2. Lower the buttonhole lever to its lowest position, and insert a 1.6 mm clearance gauge.
3. Turn the adjusting screw to the left until the LED display changes from "L" to "H".
4. Next, turn the adjusting screw to the right until the LED display changes from " H" to "L".
5. Check the LED. When the clearance of buttonhole foot is 1.4 mm, the LED displays "H"; when
the clearance is 1.8 mm, the LED displays "L".
6. Turn off the power switch.
7. Install the face plate.
Note
If there is any lint in the buttonhole sensor slit, clean out with a swab.

BUTTONHOLE

22