Miele HG05 Operating Instructions Manual page 92

Frequently Asked Questions
Problem
White residue is visible
on dishes and cutlery,
clouding occurs on
glassware; this film can
be wiped off.
There are rust stains on
the cutlery.
92
Possible cause and solution
The rinse aid dosage is too low.
 Increase the dosage (see "Settings menu, Rinse
aid").
The salt reservoir is empty.
 Fill the salt reservoir (see "Before using for the first
time, Dishwasher salt").
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.
An unsuitable Tab detergent has been used.
 Change your detergent.
The softener assembly is programmed too low for the
water hardness level.
 Program the softener assembly to a higher water
hardness level (see "Settings menu, Water hard-
ness").
The affected items are not corrosion resistant.
 There is no remedy.
Purchase cutlery which is dishwasher-safe.
A program was not run after dishwasher salt was
added. Traces of salt have got into the wash cycle.
 Always run the QuickIntenseWash program with
the Short programming option selected and with-
out any dishes in the dishwasher after adding
dishwasher salt.
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.