Clock/Timer; Clock Setting; Timer Setting; Sleep Timer Setting - Philips MCD119/05 User Manual

Clock/Timer

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

●
The system can be used as an alarm clock,
whereby DISC or TUNER is switched on at a set
time (one time operation). The clock time needs
to be set first before the timer can be used.
1
In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Press DISC or TUNER to select the desired
source.
●
Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the hours and press
SLEEP/TIMER to confirm.
➜
The minute digits flash on the display panel.
4
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the minutes and press
SLEEP/TIMER to confirm.
➜
The timer is now set and activated.
5
In standby mode, press SLEEP/TIMER on the
remote control to activate or deactivate the
timer.
➜
Display shows if activated, and disappears
if deactivated.

Sleep timer setting

The sleep timer enables the system to switch off
by itself after a set period of time.
1
In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in
minutes):
SLEEP OFF ™ SLEEP 90 ™ SLP 80 ™
SLEEP 70 ™ SLEEP 60 ™ SLEEP 50 ™
SLEEP 40 ™ SLEEP 30 ™ SLEEP 20 ™
SLEEP 10™ SLEEP OFF
➜ "SLEEP XX" or "OFF" is displayed. "XX"
denotes the time in minutes.
ß
2
When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
●
Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press ECO POWER/
STANDBY ON y (or y on the remote).
2;