Clock/Timer; Clock Setting; Timer Setting; Sleep Timer Setting - Philips MCD295/12 User Manual

Clock/Timer

Clock setting

See "Preparations-Step 2: Setting the clock".

Timer setting

●
The system can be used as an alarm clock,
whereby the last selected source is switched on
at a set time (one time operation). The clock
time needs to be set first before the timer can
be used.
1
In standby mode, press and hold TIMER for
more than three seconds.
➜ "SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2
Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the hours and press TIMER to confirm.
➜
The minute digits flash on the display panel.
3
Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to set
the minutes and press TIMER to confirm.
➜
"ON" or "OFF" flashes.
4
Turn the VOLUME control on the front panel
or press VOLUME +/- on the remote to
activate or deactivate the timer and press
TIMER to complete the setting.
➜
Display shows
if deactivated.
36
if activated, and disappears

Sleep timer setting

The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press SLEEP on the remote control repeatedly
to select a preset time.
➜
The selections are as follows (time in
minutes):
00 ™ 10 ™ 20 ™ 30 ™ 40 ™ 50 ™ 60 ™
70 ™ 80 ™ 90™ 00
➜ "SLEEP XX" is displayed. "XX" is the time in
minutes.
2
When you reach the desired length of time, stop
pressing the SLEEP button.
To deactivate the sleep timer
●
Press SLEEP repeatedly until "00" is displayed,
or press STANDBY ON y.