Table of Contents
Advertisement
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example DISC, TUNER).
3
Then select the desired function (for example
ÉÅ , à , á).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully inser t the
battery compartment back to the original
position.
1
2
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
1
2
3
4
5
6
3
Preparations
Step 2: Setting the clock
Go to Standby mode.
Press and hold DISPLAY/CLOCK on the
remote control.
➜
"SET CLOCK" is displayed briefly. Then, the
hour digits flash on the display screen.
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the hours.
Press DISPLAY/CLOCK again.
➜
The minute digits flash on the display screen.
Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the minutes.
Press DISPLAY/CLOCK to confirm the clock
setting.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 20 seconds.
Advertisement
Table of Contents
