Table of Contents
Advertisement
Using component Video In jack (Pr Pb Y)
●
Use the component video cables (red/blue/
green, not supplied) to connect the system's PR/
PB/ Y jacks to the corresponding Component
video input jacks (or labeled as Pr/Cr Pb/Cb Y or
YUV) on the TV set.
●
To listen to TV channels through this system, use
the audio cables (white/red, not supplied) to
connect AUX IN (L/R) jacks to the
corresponding AUDIO OUT jacks on the TV set.
Using an accessory RF modulator
IMPORTANT!
– If your TV set only has a single
Antenna In jack (or labelled as 75 ohm or
RF In), you will need a RF modulator in
order to view the DVD playback via TV.
See your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
RF coaxial cable to TV
ANT IN
TO TV
VIDEO
IN
Antenna or
Back of RF Modulator
Cable TV signal
(example only)
1
Use the composite cable (yellow) to connect the
system's VIDEO jack to the video input jack on
the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect the RF modulator to your TV's RF jack.
Connections
AUDIO IN
R
L
CH3 CH4
Advertisement
Table of Contents
