Before Using The Remote Control; Replacing Battery; Step 1: Setting The Clock - Philips MCD396 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.

Before using the remote control

1
Pull out the plastic protective sheet.
2
Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example CD, TUNER).
3
Then select the desired function (for example
ÉÅ , à , á).
Remove the plastic protective sheet
Replacing battery (lithium
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully insert the
battery compartment back to the original
position.
1
2
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
3

Step 1: Setting the clock

1
Go to Standby mode.
2
Press and hold CLOCK on the front panel.
➜
The hour digits flash on the display screen.
3
Turn the VOL control on the front panel or
press VOL +/- on the remote to set the hours.
4
Press CLOCK again.
➜
The minute digits flash on the display screen.
5
Turn the VOL control on the front panel or
press VOL +/- on the remote to set the
minutes.
6
Press CLOCK to confirm the clock setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 10 seconds.
Preparations
19