Setting Of Destination (Type); Overview - Canon Super G3 FAX Board-AP1 Service Manual

5
Service Mode Service Mode > Setting of Destination (TYPE) > Overview
<010: line connection identification length>
Use it to set the time for identifying the line connection.
Raise this parameter if errors occur frequently at time of communication because of the
condition of the line.
Error Code:
Any of the following error codes may be indicated because of the condition of the line
##005, ##018
MEMO:
The line condition identification time is between when the dial signal is transmitted and
when the line condition is cut for the transmitting party, while it is between when the DIS
signal is transmitted and when the line is cut for the receiving party.
<011: T.30 T1 timer (for reception)>
Set the T1 timer at the time of reception (the waiting time till receiving the significant signal
after the DIS transmission).
5 Service Mode > Setting of Destination (TYPE) > Overview Service Mode

Setting of Destination (TYPE)

Overview

When the type shown on the display is set, all the service data is set to match each country
domestic telecommunication standards.
5-16
5-16