Samsung AM***FN*D series User Manual page 38

Setting an indoor unit installation option
(suitable for the condition of each installation location)
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power supply in the indoor unit.
The panel(display) should be connected to an indoor unit to receive option.
2.
3. Set the installation option according to the installation condition of an air conditioner.
- The default setting of an indoor unit installation option is "020010-100000- 200000-300000".
- Individual control of a remote controller(SEG20) is the function that controls an indoor unit
individually when there is more than one indoor unit.
4. Set the indoor unit option by wireless remote controller.
02 series installation option
SEG1 SEG2
0 2
SEG7 SEG8
1 Drain pump
SEG13 SEG14
2 External control
SEG19 SEG20
Individual control of
3
a remote controller
1 WAY/2WAY/4WAY,DUCT MODEL : Number of hours using filter(SEG18) will be set to '1000hour' even
When setting the option other than above SEG values, the option will be set as "0".
SEG5 central control option is basically set as 1 (Use), so you don't need to set the central control
option additionally.
However, if the central control is not connected but it doesn't indicate an error message, you need to
set the central control option as 0 (Disuse) to exclude the indoor unit from the central control.
SEG3
External room
temperature sensor
/ Minimizing fan
--
operation when
thermostat is off
SEG9
Hot water heater
SEG15
External control
output / External
heater On or Off
signal
SEG21
Heating setting
compensation EEV Step of stopped
/ Removing unit during oil
condensated water return/defrost mode
in heating mode
if the SEG18 is set to exept for 2 or 6.
SEG4 SEG5
Central control
SEG10 SEG11
EEV Step when
--
heating stops
SEG16 SEG17
- Buzzer
SEG22 SEG23
-
SEG6
FAN RPM
compensation
SEG12
--
SEG18
Number of hours
using filter
SEG24
--
37