Control Assign - Roland Jx-10 Owner's Manual

* When the Memory Cartridge is not connected, be sure to set the Voice Memory switch to the "INT" position.

4.3 CONTROL ASSIGN

The JX-10 allows you to control some of the performance control functions with the Control Assign knobs on the
control panel and the Pedal Switch (DP-6 or DP-2). This is excellent for live performance. However, the functions
which can be controlled are only two of the four with the two Control Assign knobs and one of the four by the pedal
switch at a time. (See the table shown on the next
knobs and the pedal switch. The function assigned to each knob is controlled by moving the slider, and the function
assigned to the pedal switch is controlled with the pedal operation.
We call these eight functions "Control Assign functions".
PROCEDURE
1. Select the Control Assignment C1, C2 or Pedal
Switch where you wish to assign the function by
pressing the appropriate Control Assign button;
C1, C2 or PEDAL SWITCH.
The Display will now show the Control Assign
function that has been selected.
2. Rotating the α Dial, call the new function to be
assigned.
(See the table shown on the next page)
3. To continue to assign other functions, repeat
steps 1 and 2.
4. When you have completed assigning all the
Control Assign functions, press the Control
Assign button currently in use.
The Display will return to its normal indication. Whilst the Display shows the Control Assign function, nothing can
be done on the JX-10 except for playing the keyboard.
Note: When Expression Pedal EV-5 is connected to the Control Assign jack on the rear panel, the assigned Control
Assign function cannot be controlled with the Control Assign knob - only with the pedal.
Writing the Control Assignments
The Control Assign functions you have set can now be written into the JX-10's internal memory as follows:
After step 3, set the Protect Switch on the JX·10 to the OFF position, then press the WRITE Button.
The Display will respond as above, then return to its normal indication.
WRITTEN CONTROL
page). The following explains how to assign the functions to the
Manual Version 3.21
Page. 12 of 73