Roland Jx-10 Owner's Manual page 34

WRITE MASTERTUNE
WRITE CONTROLS
WRITE ARPEGGIATOR?
MIDI BULK DUMP INTERNAL?
MIDI BULK DUMP CARTRIDGE
COPY INTERNAL TO CARTRIDGE
COPY CARTRIDGE TO INTERNAL
COPY CARTRIDGE BANK
TEST MODE 1
TEST MODE 2
SEND CARTRIDGE
Press ENTER - the Master Tune setting will be saved.
Press ENTER - all C1/C2 settings (one choice for each) will be saved.
Press ENTER - the arpeggiator settings 1-7 for arpeggiator memories
A–H will be saved.
Press ENTER - the internal Patch, Tone and relevant Factors data will
be sent to the MIDI OUT port. Note that the receiver must be set to
MKS-70 not JX-10!
Press ENTER - the Cartridge Patch, Tone and relevant Factors data
will be sent to the MIDI OUT port. Note that the receiver must be set to
MKS-70 not JX-10!
Press ENTER - the internal Patch, Tone and relevant Factors data will
be copied to the inserted Cartridge.
See also page 35.
Press ENTER - the Cartridge Patch, Tone and relevant Factors data
will be copied to the JX-10 Internal memory.
See also page 35.
Press ENTER - the selected BANK of a M1024C cartridge is copied to
another selected BANK on the same cartridge.
See also page 35
Displays which sound board voices are currently playing. Also on the
JX10: Displays the A/D converter raw values in hexadecimal (C1 / C2 /
Bender / Aftertouch) and the last note played on the keyboard
(Velocity and Note Number)
Tests the memory chips (also tests the cartridge if inserted). Each time
ENTER is pressed, the test is re-run. Test is completely safe but for
peace of mind (in case of power outage etc.), you may wish to save the
memory contents before running these tests.
Press ENTER - the Cartridge Patch, Tone and relevant Factors data
will be sent to the MIDI OUT port. Note that the receiver must be set to
MKS-70 not JX-10!
Manual Version 3.21
Page. 34 of 73