Front Direction Indicator Housing; Direction Indicator Lamp Connector; Fog Lights; Side Direction Indicator Lights - Fiat 124 SPIDER 2017 Owner's Manual

5. Turn the socket and bulb assembly
counterclockwise and remove it.

Front Direction Indicator Housing

1 — Socket Assembly
2 — Bulb
6. Disconnect the bulb from the
socket.

Direction Indicator Lamp Connector

190
7. Install the new bulb in the reverse
order of the removal procedure.

Fog Lights

Proceed as follows:
1. If you are changing the right bulb,
start the engine, turn the steering wheel
all the way to the right, and turn off
engine. If you are changing the left bulb,
turn the steering wheel to the left.
2. Make sure the ignition is switched
off, and the headlight switch is off.
3. Remove the fasteners in the five
locations and partially peel back the
07031501-207-001
mud guard.
4. Disconnect the connector from the
unit by pressing the tab on the
connector with your finger and pulling
the connector.
5. Turn the socket and bulb assembly
counterclockwise, extract the bulb and
remove it;
6. Disconnect the bulb from the
socket.
7. Install the new bulb in the reverse
order of the removal procedure.
GUID-07031501208002
Brake lights / Tail lights
Go to your authorized dealer when the
replacement of this lights is necessary.

Side Direction Indicator Lights

Proceed as follows:
1. Make sure the ignition is placed in
the OFF mode, and the headlight
switch is off.
2. If you are changing the right bulb,
start the engine, turn the steering wheel
all the way to the right, and turn off
engine. If you are changing the left bulb,
turn the steering wheel to the left.
3. Remove the fasteners in the five
locations and partially peel back the
mud guard.
4. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the connector.
5. Remove the lens assembly by
pressing the tab on the unit with your
finger and pulling the unit forward to
compress in the internal catch, then pull
the cluster outwards.
6. Lift up the lens assembly, and then
remove the cluster and install the new
side direction indicator lens assembly in
the reverse order of the removal
procedure.