Tire Terminology And Definitions - Fiat 124 SPIDER 2017 Owner's Manual

DOT = Department of Transportation
– This symbol certifies that the tire is in compliance with the U.S. Department of Transportation tire safety standards and is
approved for highway use
MA = Code representing the tire manufacturing location (two digits)
L9 = Code representing the tire size (two digits)
ABCD = Code used by the tire manufacturer (one to four digits)
03 = Number representing the week in which the tire was manufactured (two digits)
– 03 means the 3rd week
01 = Number representing the year in which the tire was manufactured (two digits)
– 01 means the year 2001
– Prior to July 2000, tire manufacturers were only required to have one number to represent the year in which the tire was
manufactured. Example: 031 could represent the 3rd week of 1981 or 1991

Tire Terminology And Definitions

Cold Tire Inflation Pressure
Maximum Inflation Pressure
Recommended Cold Tire Inflation Pressure
Tire Placard
240
Term
B-Pillar The vehicle B-Pillar is the structural member of the body located behind the front door.
Cold tire inflation pressure is defined as the tire pressure after the vehicle has not been driven for
at least three hours, or driven less than 1 mile (1.6 km) after sitting for a minimum of three hours.
Inflation pressure is measured in units of PSI (pounds per square inch) or kPa (kilopascals).
The maximum inflation pressure is the maximum permissible cold tire inflation pressure for
this tire. The maximum inflation pressure is molded into the sidewall.
Vehicle manufacturer's recommended cold tire inflation pressure as shown on the tire placard.
A label permanently attached to the vehicle describing the vehicle's loading capacity, the
original equipment tire sizes and the recommended cold tire inflation pressures.
EXAMPLE:
DOT MA L9 ABCD 0301
Definition