Table of Contents
Advertisement
OPERATING YOUR VEHICLE
Sensor Locations
EXAMPLE
(2) (1) (1)
(2)
(1) Rear center sensors (2 places)
(2) Rear corner sensors (2 places)
NOTICE
• Avoid hitting the sensor areas or
directing the nozzle of a high-pres-
sure car washer onto the sensor
areas. Otherwise, the sensors may
be damaged.
• If the bumper hits a hard object, the
sensors on it may not work prop-
erly. If this occurs, have the sen-
sors inspected by an authorised
Maruti Suzuki workshop.
3-25
Working sensors
The sensors that work depends on the
position of the gearshift lever as follows:
transaxle
Gearshift lever
position
R
Center On
Rear
sensors
Corner On
79MH0307
Approximate areas where obstacles can
be detected
EXAMPLE
• An obstacle within about 20 cm (8 in)
from a sensor or just below a sensor is
not detectable.
• The sensors can detect an obstacle up to
about 1.5 m (5 ft) from the rear of vehicle.
• Under the following conditions, the
Manual
Automatic
transaxle
N, 1st
N, D, 2
R
– 5th
or L
Off
On
Off
Off
On
Off
79MH0308
WARNING
parking sensor system may not
work normally because the sensors
cannot detect obstacles correctly.
– Sensors are covered with mud,
ice or other materials. (Such
materials must be removed for
normal operation.)
– Sensors are wet from water
splashes or heavy rain.
– Sensors are covered by a hand,
sticker, accessory, etc.
– There is an accessory or other
object attached within the sen-
sor's sensing area.
– Items such as tow hooks, com-
mercially available corner poles,
radio antenna, etc. are installed
on the bumper.
– The height of the bumper is
changed due to alteration to the
suspension or other causes.
– The sensor areas are extremely
hot from direct sunlight or cold
due to freezing weather.
– The vehicle is on a rough surface,
slope, gravel road or grass field.
– The vehicle is at a steep angle.
(Continued)
Advertisement
Table of Contents
