Connecting The Ethernet Cable - D-Link DNS-1550-04 Quick Installation Manual

2. Carefully lay the disk drive into the drive tray, so that
the screw holes on the sides of the carrier align with
the screw holes in the drive.
3. Insert the screws through the holes in the drive
carrier and into the sides of the disk drive.
• Install only the counter-sunk screws supplied
with the DNS-1550-04.
• Install four screws per drive.
• Snug each screw. Be careful not to over-tighten.
4. Reinstall the drive tray into the DNS-1550-04
enclosure.
Tip: Repeat steps 1 through 4 until all of your disk
drives are installed.
To connect the DNS-1550-04 to your network:
1. Attach one end of the network cable to the RJ45 network connection. (Please refer to Figure
of DNS-1550-04 Rear View).
2. Attach the other end of the network cable to your Ethernet hub or switch.
6

3.2 Connecting the Ethernet Cable

D-Link DNS-1550-04 Quick Installation Guide