Documentation - ABB Relion 615 series Manual

Section 2
IEC 60870-5-103 overview
2.2
10
standard. It should also be noticed that these sets of data are mainly defined for a
single function protection IED. 615 series IEDs in turn are multifunctional
protection and control IEDs whose internal data model is based on the IEC 61850
standard.
Interoperability list
The standard requires the IEC 60870-5-103 device to provide an interoperability
list, which actually is more an interchangeability list. See point list manual for a
complete list of all IEC 60870-5-103 data available in a specific IED.
Data mapping principle
Almost all IEC 60870-5-103 process data in the IED is mapped into private
function types and information numbers. General principle of the mapping is to
keep all process data belonging to the same function design inside the same IEC
60870-5-103 function type definition. However, if this mapping principle causes
interoperability problems with older installations, the user can freely remap every
available IEC 60870-5-103 process data point by using PCM600.

Documentation

Address information concerning IEC 60870-5-103 process data stated in this
document is similar in all 615 series IEDs. The rest of the IEC 60870-5-103
application data are IED variant dependent.
A newer SW version of the same IED configuration may contain
additional IEC 60870-5-103 points.
The IEC 60870-5-103 points list documentation of a certain IED configuration and
SW version is available in addition to this document. It is essential to know the
device type, configuration name and SW version to locate the correct IEC
60870-5-103 points listings.
Table 2: Example of IED information needed to locate the correct IEC 60870-5-103 points list
LHMI or WHMI path
Information/Product identifiers/Type
Information/Product identifiers/Configuration name
Information/Product identifiers/SW version
IED information
REF615
FE01
1.0
Communication Protocol Manual
1MRS756710 C
615 series