Page 2
This product can be used in the following modes: Infant/Toddler Feeding Booster Seat Highchair (Infant seat attached to chair)
Page 3
Failure to follow these warnings and the assembly instructions could result in serious injury or death. PLEASE SAVE OWNER’S MANUAL FOR FUTURE USE. PREVENT SERIOUS INJURY OR DEATH. Do not use in motor vehicles. FOR YOUR CHILD’S SAFETY, read the labels and the owner’s manual before using product.
Page 4
This model may not include some features shown below. Check that you have all the parts for this model BEFORE assembling your product. If any parts are missing, call Customer Service. No tools required. ACCESSORIES ON CERTAIN MODELS...
Page 5
Assembling Highchair To set up, squeeze buttons on either side of highchair legs and push front legs forward as shown. Attach legrest by snapping it onto center bar as shown. Rotate legrest down to secure. Be sure the bar is securely attached into the legrest as shown.
Page 6
Insert footrest into slots as shown. Rotate footrest down to secure. You may need to adjust position of footrest once your child is seated in chair.
Page 7
Infant/Toddler Feeding Booster Seat Assembly While pulling up on handle on seat back, insert seat back, into the slots on the seat base as shown. Release handle on back and allow rods on side of seat back to insert into one of the sets of holes in the seat base.
Page 8
Seat Pad Insert webbing through opening in seat back as shown. Attach seat pad to infant/toddler feeding booster seat as shown. Pull waist straps through openings in seat pad. Pull shoulder straps and crotch strap through openings in seat pad.
Page 9
Wrap seat pad over the top of the infant/toddler feeding booster seat. Make sure recline handle is sticking out the hole in the seat pad. Secure seat pad with hooks as shown.
Page 10
Secure seat pad with hooks at the front of seat as shown. Fasten snaps as shown. SNAP!
Body Support Place body support on top of the seat pad. Pull waist straps through openings in body support. Pull shoulder straps through openings in body support.
Page 12
Attaching Infant/Toddler Feeding Booster Seat to Highchair Place infant/toddler feeding booster seat on highchair. NOTE: Be sure that guides on sides of infant/toddler feeding booster seat go into channels on highchair arms as shown. Make sure the clear compartment holding the straps under the seat is closed before attaching seat to highchair frame.
Page 13
Tray SNAP! To attach tray, squeeze both side handles on bottom of tray and place on highchair or squeeze button and slide on. To remove tray, squeeze both side handles on bottom of tray and lift up or squeeze button and slide off.
Tray Cover Dishwasher safe. Attach tray cover by pushing it down on the tray. To remove pull up on the back of the tray.
Page 15
WARNING Always use the seat belt. To convert to 3-pt harness. Use slide adjuster at shoulder and waist for Use slide adjuster at tighter adjustment. waist for further adjustment.
Page 16
When changing harness strap slots, MAKE SURE harness straps are going through same slots in seat pad and seat back. The harness straps must go into slot that is even with or slightly above the shoulders. Avoid twisting straps.
Page 17
WARNING: DO NOT adjust the height of the product with the child in it. To adjust height, squeeze buttons on the back of both legs and lower or raise seat. There are 5 height positions.
Page 18
Recline WARNING: DO NOT adjust the seat recline with the child in it. Squeeze handle on back of seat and push down or pull up to adjust. There are 3 recline positions.
Page 19
Attaching infant/toddler feeding booster seat to chair Turn infant/toddler feeding booster seat over. Open clear compartment on bottom of infant feeding booster seat. Pull straps out of compartment as shown. Insert two rear straps into slots in infant/toddler feeding booster seat as shown. Tabs MAKE SURE belt is placed over top of plastic tabs on bottom of seat as shown.
Page 20
Place infant/toddler feeding booster seat on a chair with no armrests and that has a back, ensuring that the straps are hanging freely. Make sure that there are no extra seatpads or cushions on the chair that you are using with the infant/toddler feeding booster seat.
Page 21
Ensure the infant/toddler feeding booster seat is attached correctly by pulling up on it.
Page 22
To remove infant/toddler feeding booster seat from chair Unfasten clips on bottom of seat. SNAP! Unfasten clips from back of seat. SNAP!
Page 23
Remove infant/toddler feeding booster seat from seat. Fold and store straps in compartment on bottom of infant/toddler feeding booster seat as shown. Close compartment door. MAKE SURE the compartment door is closed before attaching infant/toddler booster seat back onto the highchair frame.
Care and Maintenance BEFORE EACH USE. Inspect the highchair for damaged hardware, loose joints, missing parts, or sharp edges. DO NOT USE highchair if any parts are missing or broken. DO NOT substitute parts. TO CLEAN HIGHCHAIR use only household soap and warm water. NO BLEACH or detergent. TO CLEAN REMOVABLE SEAT COVER, Refer to your care tag on your seat pad for washing instructions.
Need help?
Do you have a question about the PD202866AL DUODINNER and is the answer not in the manual?
Questions and answers