Xerox Phaser 3600 Instruction page 14

35. Clean out any remaining toner from both halves of the
assembly. Make sure the foam seals are clean. Also, if the sup-
ply roller is worn, it can now be easily replaced.
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
XEROX PHASER 3600 • TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
34. Remove the center screw from the toner hopper.
The top half of the developer roller assembly will now come free.
36. Install the seal fold over the pull-tab so it sits over the foam
edge seal. Slide the tab through the slot.
www.uninetimaging.com