Connect Your Wireless Access Points - TRENDnet TEW-WLC100 Quick Installation Manual

3. Connect your wireless access points

Important Note: Please make sure your access points have met the requirements in Section 1.
1. Using an Ethernet cable, connect each wireless access point to the wireless controller or your
network.
Note: If powering the access points using their power adapters, you can connect the access
points directly to your network or the wireless controller. If powering the access point using
power over Ethernet (PoE), you can connect your access points to your network or to the
wireless controller using a separate PoE injector (not included) or PoE/PoE+ switch (not
included).
Network Network Network
OR OR
Access Point PoE Injector
PoE Switch
Access Point Access Point
Power
7