Protocols Ospfv3 Abr-Type - Brocade Communications Systems 5600 Configuration Manual

protocols ospfv3 abr-type

Sets an OSPFv3 Area Border Router (ABR) type.
Syntax
set protocols ospfv3 [ process
delete protocols ospfv3 [ process
Command Default
The default ABR type is cisco.
Modes
Configuration mode
Configuration Statement
protocols {
ospfv3 {
process process-id {
abr-type {
cisco
ibm
standard
}
}
}
}
Usage Guidelines
Sets an OSPFv3 ABR type.
Specifying the ABR type allows better functioning in a multi-vendor environment. The following ABR types are supported:
∙
Cisco (RFC 3509): A router is considered an ABR if it has more than one area actively attached and one of them is
the backbone area.
∙
IBM (RFC 3509): A router is considered an ABR if it has more than one area actively attached and the backbone area
is configured. In this case, the configured backbone need not be actively connected.
∙
Standard (RFC 2328): A router is considered an ABR if it has more than one area actively attached to it.
Use the set form of this command to set an OSPFv3 ABR type.
Use the delete form of this command to set cisco as the defaut ABR type.
52
process-id ] abr-type { cisco | ibm | standard }
process-id ] abr-type
OSPFv3 Commands
Brocade 5600 vRouter OSPFv3 Configuration Guide, 5.0R1
53-1004503-01