Devine SUB 115A User Manual page 6

Practical information and tips for optimal use of your speaker system
For optimal performance and a long lifespan of your speaker, please pay attention to the following
when using your Devine subwoofer:
- This speaker is equipped with a CLIP limiter, which prevents damage to the speaker. This CLIP
limiter will activate at excessive volume levels and a red LED shows when the CLIP limiter is active.
Prevent the activation of the CLIP limiter system and the indicating LED. The CLIP limiter protects the
system from permanent damage, but is only effective at peak signals. Long term exposure causes
distortion and power overload, with possible permanent damage to your speaker system.
- When using an external mixer (such as a PA-mixer or DJ-mixer, make sure your master channel
sends out signals at 0dB maximum. This will provide optimal signal quality and with the volume control
on the speaker you are able to turn up the volume, just before the CLIP limiter LED will slightly flash.
This way you are using the speaker to its full potential with optimal sound quality.
- When using the crossover system and adjusting the volume and/or frequency balance between your
speakers and subwoofer(s), keep the master volume on a medium, neutral level which is comfortable
to your ears.
- Do not remove the protective cover in front of the voltage-switch. The correct voltage is pre-defined
at 230V AC. When selecting the wrong voltage you may cause permanent damage to the speaker and
its internal components. Only select the 115V AC option when your local power source is capable of
delivering this voltage.
- Do not switch the power on and off frequently as this reduces the lifespan of the speaker and its
internal components. The speaker can be used for a whole day without any cooling-down time, if
sufficient cooling is provided.
- The speaker is equipped with an internal fuse, located directly above the IEC power input section. If
this fuse blows for any reason, only replace it with a fuse that has the same values as the original fuse.
Do not bridge the gap with any electrical wiring or whatsoever as this voids your warranty.
- Severe shocks and impact must be prevented as much as possible. Secure this speaker properly in
place during transport to prevent damage to the housing and the internal components of the speaker.