•
[15 Mins], [30 Mins], [45 Mins], [60 Mins] -
Select the countdown time for this product to
switch to standby.
[Auto Standby]
Turn on/off the auto standby mode.
•
[On] - Switch to standby after 15 minutes
of inactivity (for example, in pause or stop
mode).
•
[Off] - Disable the auto standby mode.
Audio setup
1
Press SETUP.
» [General Setup] menu is displayed.
2
Press
to select [Audio Setup], and then
press
to enter the submenu.
3
Select an option, and then press OK.
4
Select a setting, and then press OK.
•
To return to the previous menu, press
BACK .
•
To exit the menu, press
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
•
[LT/RT] - For the surround sound output
through two speakers.
•
[Stereo] - For the stereo output.
•
[Multi Channel] - For multi-channel output.
[Volume]
Set the default volume level when you play a disc.
1. Press OK.
2. Press
to set the volume.
3. Press OK to confirm and exit.
[Sound Mode]
Select a preset sound effect to enhance the audio
output.
•
[3D] - Select a virtual surround sound effect
that is produced from the left and right audio
channels.
12
EN
SETUP.
•
[Movie Mode] - Select a sound effect for
movies.
•
[Music Mode] - Select a sound effect for
music.
[Speaker Setup]
Optimize the surround output for the connected
speakers.
[CD Upsampling]
For better sound quality in stereo mode, convert
the music CD to a higher sampling rate.
•
[Off] - Turn off CD-upsampling.
•
[88.2kHz] - Convert to twice the original
sampling rate.
•
[176.4kHz] - Convert to four times the original
sampling rate.
[Night Mode]
Make loud sound level softer and soft sound level
louder so that you can watch the DVD movies at a
low volume, without disturbing others.
•
[On] - Enjoy quiet viewing at night.
•
[Off] - Enjoy surround sound with a full
dynamic range.
Note
•
Applicable only to Dolby Digital encoded DVDs.
Video setup
1
Press SETUP.
» [General Setup] menu is displayed.
2
Press
to select [Video Setup], and then
press
to enter the submenu.
3
Select an option, and then press OK.
4
Select a setting, and then press OK.
•
To return to the previous menu, press
BACK.
•
To exit the menu, press
[TV System]
Change this setting if the video does not appear
correctly. By default, this setting matches the most
common setting for TVs in your country.
SETUP.