Gas Connection - Baumatic B6FS User Manual

5) GAS CONNECTION

The gas connection is located in the rear and on the
underside of the appliance 118 mm (for 60 cm),
165 mm (for 70 cm), 255 mm (for 90 cm) from the
right hand side.
There are two ways to carry out the connection to the
main gas line:
A. The hotplate can be connected with rigid pipe as
specified in AS/NZS 5601.
B. If installing with a hose assembly, install with a
hose assembly that complies with AS/ANZ 1869
(Australian Certified), 10 mm ID, class B or D, no
more than 1.2 m long and in accordance with
AS/NZS 5601. Ensure that the hose does not contact
the hot surfaces of the hotplate, oven, dishwasher or
any other appliance that may be installed underneath
or next to the hotplate. The hose should not be
subjected to abrasion, kinking or permanent
deformation and should be able to be inspected
along its entire length with the hotplate in the
installed position.
Unions compatible with the hose fittings must be
used and all connections tested for gas leaks.
The gas supply connection point must be accessible
with the appliance installed.
FIG. 13/A
FIG. 11
INSTALLATION
Natural Gas
Natural Gas installations require the connection of a
gas regulator at the appliance. This regulator is
supplied with the appliance on purchase.
Assemble the regulator (noting the gas flow
direction) and transition pieces (supplied with the
appliance), in accordance with figure 11.
The transition piece on the supply side of the
regulator must be provided by the installer.
Liquified Petroleum Gas
In a U-LPG installation the gas regulation is made
at the gas cylinder and regulation at the appliance
is not required. To connect supply to the appliance
use
figure 12. These pieces are supplied with the
appliance on purchase.
WARNING:
THE BURNER FLAME MUST BE ADJUSTED BY
THE INSTALLER.
FAULTY
COVERED UNDER WARRANTY.
THE APPLIANCE IS FACTORY SET FOR NATURAL
GAS. THE TEST POINT PRESSURE SHOULD BE
ADJUSTED TO 1.00kPa WITH THE WOK BURNER
OPERATING AT MAXIMUM.
9
transition pieces
INSTALLATION
FIG. 13/B
FIG. 12
as shown in
WILL NOT BE