Installation - Baumatic B6FS User Manual

TECHNICAL INFORMATION FOR
INSTALLATION PERSONNEL
This appliance shall be installed only
by authorised personnel and in accordance
with the manufacturer's installation
instructions, local gas fitting regulations,
municipal codes, electrical wiring regulations,
AS 5601/AG 601-Gas Installation and any
other statutory regulations. Ventilation must
be in accordance with AS 5601/AG 601- Gas
Installation. In general, the appliance should
have adequate ventilation for complete
combustion of gas, proper flueing and to
maintain temperature
surroundings within safe limits. The wall and
bench surfaces must be capable of sustaining
temperatures of 75 °C.
All laminates, fixing adhesive and surfacing
materials should be certified suitable for this
temperature.
Any adjoining wall surface situated within 200 mm
from the edge of any hob burner must be a suitable
non-combustible material for a height of 150 mm for
the entire length of the hob. Any combustible
construction above the hotplate must be at least
650 mm above the top of the burner and no
COMPLY WITH THE DIMENSIONS
Overall Dimensions 4F: 580 x 500 mm
Overall Dimensions 5F: 860 x 500 mm
A
4F (580) 553
5F (860) 833

INSTALLATION

of immediate
B C D
473 63.5 63.5 100 min.
475 62.5 62.5 73.5 min.
FIG. 7
construction shall be within 450 mm above the top
of the burner. A minimum depth of 70 mm from the
top of the worktop surface must be provided for the
appliance.
In line with Australian regulations A bottom part of
the rangehood can be installed at 600mm from the
hihgest point of the gas cooktop.
3) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within children's
reach since they could become potential sources of
danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in fig. 7.
Always comply with the measurements given for the
hole into which the appliance will be recessed
(see fig. 7 and 8).
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
E
7
FIG. 8