Connecting External Data Media; Removing The External Data Media - Beko 42BLE5520BN Operating Instructions Manual

USB­OPERATION
Connecting­external­data­media­
Before connecting the external data medium it is
recommended to switch the television to stand-by
mode.
Before removing the external data medium,
the television set must be switched to standby,
so that no data loss occurs.
Notes:
The »USB2« socket of the television set
7
s upplies a maximum power of 500 mA in
accordance with USB specifications. Exter-
nal hard disks which require more power
may therefore only be connected to the
»USB1« of the television set.
If you use a network cable for external hard
7
disks which are connected to the »USB1«
socket on the television, this network cable
must also be disconnected from the power
supply when the television is switched off.
External data media may not be disconnect-
7
ed from the television set while files on the
data medium are being accessed.
A bi-directional data transfer as defined for
7
ITE (Information Technology Equipment)
d evices in EN 55022/EN 55024 is not
possible.
U SB transfer is not in itself an operating
7
mode. It is only an additional function.
­---------------------------------------------------------------------------------------------------------------
1 Press »
on the television from standby mode.
2 Connect the »USB1« socket of the television
and the corresponding socket on the data
device (external hard drive, digital camera,
card reader or MP3 player) using a USB ca-
ble;
or
insert the USB plug of the USB memory stick
into the »USB2« socket of the television set.
Removing­the­external­data­
media
Before removing the external data medium, log
off the data medium.
1 Open the menu with »MENU«.
2 Select the menu item »USB« with »
»
3 Select the line »Safely Remove Disk« with
»
Note:
7
8 «, »1...0« or »P+« or »P-« to switch
« and press »OK« to confirm.
Λ
« or » « and press »OK« to confirm.
V Λ
The data medium can now be removed from
the socket.
« or
V
­ 2 9
ENGLISH