Displaying Signal Information - Beko 42BLE5520BN Operating Instructions Manual

SPECIAL­SETTINGS
Creating­lists­of­favourites
You can select your favourite channels and save
them in up to four favourites lists (Fav 1 to Fav 4).
1 In the »PROGRAME TABLE« menu, switch
over to the list view with »
2 Select the preferred channel with »
or » «.
Λ
< >
3 Use » « or » « to "push" the channel into
one of the favourites lists 1 to 4 and press
»OK« to confirm.
– T he position in the favourites list is marked
with »✔«.
– Y ou can enter the same channel in more
than one favourite list.
– Each favourite list can store up to
250 channels.
Note:
Channels can also be deleted from favour-
7
ites lists. Select the channel to be deleted
with » «, » «, »
V Λ
»OK«.
Exiting­the­settings
1 Press »EXIT« to end the setting.
­ - ---------------------------------------------------------------------------------------------------------
« (yellow).

< >
« or » « and delete it with
Displaying­signal­information
(for digital channels only)
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP« with
» « or »
V Λ
«
V
3 Select the line »Signal Information« with
» « or »
V Λ
– I nformation on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
T he signal information changes in ac c ord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4 Press »EXIT« to close the menu.
« and press »OK« to confirm.
« and press »OK« to confirm.
ENGLISH
­ 5 7