Section 4 Battery Pack Replacement - Icom IC-M25 Service Manual

SECTION 4
NOTE:
• Before the disassembly, dry the transceiver if it is wet.
• Dispose the old battery pack according to the laws in your
area.
1. Removing the old battery pack
1) Remove the 6 screws from the rear panel.
Doubled-sided tapes
(Supplied in pair)
2) Carefully separate the rear panel and turn it over in
order to disconnect the battery connector and the
red sensor connector.
Sensor connector
Sensor connector
Sensor connector
3) Pull the old battery pack off the rear panel.
•
If the double-sided tape is adherent to the rear panel, re-
move it.
BATTERY PACK REPLACEMENT
Indication lines
Rear panel
Rear panel
Rear panel
Doubled-sided tapes
(Supplied in pair)
2. Installing the new battery pack
1) Glue the ferrite core to fix its position.
Ferrite core
3 to 4 mm
(1/8 to 5/32 inches)
2) Separate the double-sided tapes, which are sup-
Indication lines
plied with the battery pack.
3) Apply the double-sided tapes in the position as
shown below, and then peel the protect sheets.
Indication lines
Doubled-sided tapes
(Supplied in pair)
4) Apply the new battery pack in the position on the
rear panel as shown below.
5) Re-assemble the transceiver.
4-1
Glue
Manufacture: Cemedine Inc.
Name: Super-X
Indication lines
Indication lines
Ferrite core
3 to 4 mm
(1/8 to 5/32 inc
Indication