Getting Started; Standby/Switching On/Switching Off; Connecting Headphones; Connecting An Audio Device - Sonoro Cubo Instruction Manual

2. Getting started

2.1 Standby/Switching on/Switching off

The device is now in standby mode. The time display lights up. To switch the device on
and off, use the STANDBY button.

2.2 Connecting headphones

Headphones may be connected to the device. Connect the headphones to the headphone
connector at the rear of the device.

2.3 Connecting an audio device

You can connect an external audio device, e.g. an MP3 player, iPod
device. Please use a suitable audio cable and connect the external device to the AUX-IN jack
on the rear of the cubo. Select AUX mode by pressing the MODE button (AUX will appear on
the display).

2.4 Connecting the antenna

Connect the supplied antenna to the antenna socket (ANTENNA). If the radio reception is not
satisfactory, please try to improve the reception by adjusting the antenna. If you have a roof aerial
which is customised for DAB+/DAB, you can connect it to the antenna connector on the unit.
An antenna connection cable is required; this can be obtained from specialist dealers.

2.5 Adjusting tone (bass/treble)

1. Press the MENU button.
2. Press SKIP until Set-Tone appears on the display.
3. Press the MENU button and set the bass level with the volume buttons.
4. Press SKIP again to set the treble level.
5. Confirm your selection by pressing

2.6 Pairing the remote control

1. Insert a lithium battery (button cell type CR2032) into the remote control with the +pole
facing upwards and close the sliding cover.
2. Press the STANDBY button on the device to switch it off.
3. Press and hold the
display.
4. Then press and hold the
control. When pairing has been completed successfully, "Pairing" appears on the display.
MENU.
REVERSE (SKIP) and VOLUME+ buttons until "Remote" appears on the
MODE and TUN+ buttons on the remote control to pair the remote
, Notebook or similar
®
7