Fm Radio Operation; Setting The Stations; Storing And Calling Up Stations; Dab+/Dab Radio Operation - Sonoro Cubo Instruction Manual

5. FM Radio Operation

While the device is switched on, select radio operation with the MODE button.
The display will show „FM Ready", then the FM radio frequency.

5.1 Setting the stations

Press the TUNING + or TUNING - button to manually search for a radio station. To automati-
cally scan for stations, press and hold the button for two seconds until the scanning begins. If
you find the radio reception unsatisfactory, you can either connect the cubo to your roof aerial
which is customised for DAB+/DAB or try to improve the reception by redirecting your telescope
antenna. The tuner is very sensitively adjusted and it may therefore suffice for you to alter the
frequency of your desired station upwards or downwards by 0.05 MHz.

5.2 Storing and calling up stations

1. Find your desired station.
2. Hold one of the station buttons above the loudspeaker pressed until you hear a short
"beep". The station is now stored at this position.
To select the station again, you only need to press the corresponding station button.

6. DAB+/DAB Radio Operation

Select DAB+/DAB radio operation with the MODE button (DAB+/DAB, FM, CD, iPod, AUX)
while the device is turned on. The display will indicate "DAB Ready, Tuning...".

6.1 Full Scan, automatic station search (Channel 5...13)

For a full scan, press the TUNING - button for at least two seconds to start the station scan. The
DAB cubo will automatically start a complete scan across the entire frequency band. The dis-
play will first show "F Scan" and then the scanning progress in %. Then the number of received
services (radio stations) will be shown on the display, e.g. : 10 Serv.
The DAB cubo stores the number of available stations alphanumerically and will automatically
jump to the first available station.
If no reception is available (e.g. the antenna is not plugged in, interferences) the display will
indicate: Sig N/A (signal not available).
If no program is being broadcast by a received station, the display will indicate: "0 Serv"
(service not available).
12